Tuesday 23 January 2018

RPO Part 4

Trucks

The Branchline under frame is designed to work with the kit supplied 3 axle trucks.  ACF built these RPO cars with short wheel base, 2 axle trucks.  The Walters 8'6" passenger car truck was selected as the closest to the prototype.  In order to mount these trucks, the under frame was modified in the following manner.

1. Mill off the bolster even with the surounding material.

2. Install a block of styrene for the truck to rest on, that provides for the correct coupler height.

3. Drill the truck mounting screw on center and the correct distance from the car end.  To ensure the screw is centered, I coloured the block with some pencil graphite and then used my dividers to scribe two arcs using the moulded holes near the end of the car, on either side of the coupler.

4. The smaller piece of styrene helps to keep the Branchline swinging coupler box wiskers,  flat against the under frame, improving the coupler mounting box angle.

5. The openings were filled with sheet styrene from the inside.



The trucks were modified by adding a small washer to fill in the large hole to size it for a 2-56 screw.  These were glued using ACC.


 The underframe was detailed the best I could figure from my reference photos and a photo supplied by one of the blogs readers, of his Bethlehem Car Works kit of this car.

 The Sill steps were formed from Details Associates flat stock in a simple wood jig and soldered together.

 The roof was sanded of all detail including the panel lines, as they were in the wrong location for this car.  The panel lines were recreated, by first priming the roof, then masking off the half of the panels, followed by adding 4 more coats of primer.  The masking tape was removed shortly after the last coat, while the paint was still soft, so that it would not chip.

The roof was detailed with Custom Finishing Vents, brass bar stock for the drip rails above the doors and a brass wire with mounts for the Gas Lighting Pipe.




In the next installment I will show the final car so Stay tuned.....


6 comments:

  1. Wow Ryan, the car is looking good thus far. You have a remarkable set of modeling skills.

    Best, Scott

    ReplyDelete
  2. Your RPO is coming great! I will remember the paint trick you used on the roof to simulate the panel lines, have not seen that before, thanks for sharing that idea.

    Joe Smith

    ReplyDelete
    Replies
    1. Thanks Joe, the panel line trick works well and is actually really easy to do I hope it works for you.

      Delete
  3. Service gui hang di My Mercedes car accessories are beautiful and genuine

    ReplyDelete